LIVE CENTRE SYSTEM
unique combination centre system provides a high quality, comprehensive
tailstock support for virtually all spindle turning requirements.
It has over 7 functions in
one handy unit. Precision machined and 3 bearings for maximum long life.
- Fast, precise and powerful tailstock
- Designed for the tough demands of
- 2 year warranty
- Versatile – over 6 functions in one
- Quick change tapers.
Fast mounting of centre pieces.
- Long life quality triple bearing
- Fits all lathes with standard MT
- Includes unique stepped cone system as
standard, allowing ultra fast and convenient mounting of work.
- Can handle both heavy and delicate
- Can handle both hard and soft woods
- Hollow centre allows the user to drill
through centre. Great for cable access for lamps etc
- Instruction manual included
quick change Morse Taper (2MT)
Fits all NOVA lathes and other
lathes have 2MT.
However, for lathes with 1 or 3 MT,
by using appropriate adaptor, this unit can be fitted also.*
* 4MT or larger adaptor should
not be used.
This centre has an internal thread
to mount either a bolt or a screw (hanger bolt)
This enables the centre to be used
to mount wooden plugs, disks or mandrels as support pieces for
turning either bowl work or spindle applications.
With it's internal cone form, this
centre can also be used for quick centreless mounting of squares
or rounds up to 8mm for spindle applications.
This centre is also needed to mount
the large stepped cone accessory.
This item is designed to support
thin work or small, delicate turnings.
The diameter of the stem is
1/4" so this centre can double as a 1/4" pen mandrel.
Two of these centres could be used
for each half of the pen mandrel - one being fixed in the Live
Centre, the other being located in the headstock spindle.
It is good all purpose centre
designed for a wide variety of applications. Ideal for medium to
cup centre and point
Ideal for softwood support, the
Hollow Cup Centre comes with it's own demountable centre point.
By using the hollow cup centre,
turners will able to dig a hole within the spidle item.
The Stepped cone is a quick and
convenient way to mount centreless rounds up to 40mm(19/16"),
split turning or other work without a centre. Reverse mounting of
cone allows wedge fit of hollow section work.
Needs the Threaded Centre to mount
it on the Live Centre.
NOVA Tailstock Chuck
The Tailstock Adaptor is a brand new accessory for the Nova Live
Allows for perfect alignment when remounting
work to turn the other side in dead or live mode, saving you
time and material normally wasted in truing work piece up
In live mode it can also be used to support work
with a chuck e.g. in conjunction with vacuum chucking.